OSHA Requirements and Training Resources for Longview TX
OSHA training for private companies in Longview TX is regulated by the Federal Occupational Safety and Health Administration (OSHA). The state of Texas does not operate an approved state OSHA program for public employees at the state or political sub-division (e.g.: municipal, Gregg county, public school or college) level.
OSHA Training Regulations and Standards
Regulated employers located in Longview Texas are governed by the Federal OSHA health and safety standards found in the 29 Code of Federal Regulations (CFR). These include, but are not limited to, the OSHA workplace poster requirements in Part 1903, OSHA injury and illness record-keeping requirements in Part 1904, general industry standards in Part 1910, maritime standards in Parts 1915, 1917 and 1918, construction standards in Part 1926, and agricultural standards in Part 1928.
Links to federal OSHA training requirements for construction and general industry are available below on this page.
Federal OSHA exercises jurisdiction over most private employers in the state of Texas. Federal employers in TX also operate under the jurisdiction of Federal OSHA. There is one OSHA area office serving the Longview TX area:
Dallas Area Office
1100 East Campbell Road
Richardson, TX 75081
The OSHA national emergency hotline telephone number is 1-800-321-OSHA.
OSHA Training Resources
OSHA Training Conducted by Our Local Trainers in English or Spanish at Your Site in Longview TX (see available courses below)
On-Site OSHA Training Classes IN Longview TX
Request a proposal for On SIte osha training in Longview TX
Disclaimer: This information was obtained from the Federal OSHA website. OSHA Training Services Inc. makes every effort to ensure that the information on this page is accurate and up to date, but changes in state law and procedures affecting the information on this page are beyond our control. Contact OSHA program staff directly to verify important information about OSHA training requirements in Longview TX.