OSHA Training in the Texas Panhandle

OSHA Training in the Texas Panhandle

Worker safety for private companies in the state of Texas is regulated by the Federal Occupational Safety and Health Administration (OSHA). The state of Texas does not operate an approved state OSHA program for public employees at the state or political sub-division (e.g.: municipal) level.

OSHA Regulations and Standards

Regulated employers located in the state of Texas are governed by the Federal OSHA health and safety standards found in the 29 Code of Federal Regulations (CFR). These include, but are not limited to, the OSHA workplace poster requirements in Part 1903, OSHA injury and illness recordkeeping requirements in Part 1904general industry standards in Part 1910, maritime standards in Parts 1915, 1917 and 1918, construction standards in Part 1926, and agricultural standards in Part 1928. 

Jurisdiction

Federal OSHA exercises jurisdiction over most private employers in the state of Texas. Federal employers in TX also operate under the jurisdiction of Federal OSHA. There is one OSHA area office located in the Panhandle region:

Lubbock District Office
1205 Texas Avenue, Room 806
Lubbock, TX 79401

The OSHA national emergency hotline telephone number is 1-800-321-OSHA. You can reach OSHA Training Services Inc in Texas at 1-877-771-6742.

 

Other Resources

State of Texas OSHA Poster

OSHA Training Requirements for 1910 General Industry

OSHA Training Requirements for 1926 Construction

 

back >


Disclaimer: This information was originally obtained from the Federal OSHA website. OSHA Training Services Inc. makes every effort to ensure that the information on this page is accurate and up to date, but changes in state law and procedures affecting the information on this page are beyond our control. Contact state program staff directly to verify important information.

 

OSHA training in Amarillo TX

OSHA training in Pampa TX

OSHA training in Canyon TX

OSHA training in Lubbock TX

OSHA training in Childress TX

OSHA training in Hereford TX

OSHA training in Plainview TX

OSHA training in Dalhart TX

OSHA training in Dumas TX

OSHA training in Borger TX

 

Need OSHA Training in the Texas Panhandle?


Contact

OSHA Training Services

Offering the following on-site OSHA training courses for your group throughout the Texas Panhandle:

OSHA 10 Hour Training - Construction

OSHA 10 Hour Training - General Industry

OSHA 30 Hour Training - Construction

OSHA 30 Hour Training - General Industry

Competent Person Training for Excavations

Confined Space Entry Training

Hazwoper Training

. . . and a whole lot more!

osha_request_proposal.gif

- Click Button -

or call 1-877-771-6742