OSHA Training in San Angelo TX

OSHA Training in San Angelo Texas

Worker safety for private companies in the state of Texas is regulated by the Federal Occupational Safety and Health Administration (OSHA). The state of Texas does not operate an approved state OSHA program for public employees at the state or political sub-division (e.g.: municipal) level.

OSHA Regulations and Standards

Regulated employers located in San Angelo Texas are governed by the Federal OSHA health and safety standards found in the 29 Code of Federal Regulations (CFR). These include, but are not limited to, the OSHA workplace poster requirements in Part 1903, OSHA injury and illness recordkeeping requirements in Part 1904general industry standards in Part 1910, maritime standards in Parts 1915, 1917 and 1918, construction standards in Part 1926, and agricultural standards in Part 1928. 

Jurisdiction

Federal OSHA exercises jurisdiction over most private employers in the state of Texas. Federal employers in TX also operate under the jurisdiction of Federal OSHA. There are two OSHA offices located near San Angelo TX:

Austin Area Office
La Costa Green Bldg.
1033 La Posada Dr. Suite 375
Austin, TX  78752
(512) 374-0271

Fort Worth Area Office
North Starr II, Suite 302
8713 Airport Freeway
Fort Worth, TX 76180
(817) 428-2470 

The OSHA national emergency hotline telephone number is 1-800-321-OSHA.

Other Resources

State of Texas OSHA Poster

OSHA Training Requirements for 1910 General Industry

OSHA Training Requirements for 1926 Construction

 

back >


Disclaimer: This information was originally obtained from the Federal OSHA website. OSHA Training Services Inc. makes every effort to ensure that the information on this page is accurate and up to date, but changes in state law and procedures affecting the information on this page are beyond our control. Contact state program staff directly to verify important information.

 

 

 

OSHA 10 hour training San Angelo TX

OSHA 30 hour training San Angelo TX

Confined space entry training San Angelo TX

Excavation competent person training San Angelo Texas

 

Need OSHA Training in San Angelo Texas?


Contact

OSHA Training Services

Offering the following on-site OSHA training courses for your group in the San Angelo TX area:

OSHA 10 Hour Training - Construction

OSHA 10 Hour Training - General Industry

OSHA 30 Hour Training - Construction

OSHA 30 Hour Training - General Industry

Competent Person Training for Excavations

Confined Space Entry Training

Hazwoper Training

. . . and a whole lot more!

osha_request_proposal.gif

 

Click the Button

or

call 1-877-771-6742